Ventilation and cooling solution for steel structure factory buildings

Cooling steel structure factories 　　in summer is a problem for many factories. The factory area is large and the height is high. When the outdoor temperature is 35°C, the temperature inside the factory may be above 40°C, and the top may reach 50°C or even higher. The investment cost of traditional air-conditioning cooling is too high. , the subsequent electricity cost is higher, roof insulation cannot solve the fundamental problem, and the improvement effect is not good.

　　Problems with steel structure factory buildings:

　　1. The area is large and high, making it difficult to find suitable cooling equipment;

　　2. The roof of the iron house is poorly insulated. In the summer, the temperature is abnormally high. Generally, the indoor temperature is more than 5℃ higher than the outdoor temperature;

　　3. Because the iron sheet room is large and the personnel are scattered, it is very difficult to lower the overall temperature.

 

 

　　The poor environment of steel structure factory buildings affects enterprises:

　　The steel structure factory building is a steel structure. Although the floors are high and insulated, the workshop is still unbearably hot in summer. Workers sweat and sweat while working inside, which affects work efficiency. In severe cases, heatstroke often occurs.

　　Cooling solution for steel structure factory building - recommended Keruilai environmentally friendly air conditioner:

　　1. Strong cooling effect: In hot areas, environmentally friendly air conditioners can generally achieve a cooling effect of 4-10°C, and the cooling effect is rapid.

　　2. Large air volume and long air supply: The maximum air volume per hour is 18000-60000m³, which can be selected according to customer requirements. Our machine has large air pressure and long air supply.

　　3. Stable performance and reliable quality: The use of 100mm rear "5090 evaporation rate net" has strong cooling ability, and the use of three-blade forward-swept axial flow fan blades has low noise and high efficiency.

　　4. Energy saving: One installation per 100-150 square meters requires only 1 kilowatt hour of electricity per hour.

　　5. Energy saving: energy consumption is only 1/8 of traditional air conditioners, and investment is only 1/5 of central air conditioners.

　　6. It can be used in both open and semi-open workshops without environmental restrictions.

　　Cooling solutions for steel structure workshops:

　　1. Overall cooling: The overall cooling of the environmentally friendly air conditioner can quickly reduce the temperature of the factory floor by 4℃-10℃, replace the indoor air more than once per minute, and continuously deliver fresh cold air to the outdoors in a positive pressure manner to remove the hot and turbid indoor air. Squeeze it out to cool down and at the same time ventilate, remove dust and remove odor. The standard configuration is 1 set per 100 square meters, 1.1kw power environmentally friendly air conditioner with 1°C electricity per hour.

　　2. Post cooling: An economical and practical way to cool down the working area of ​​the staff, using direct air blowing or pipe type, which not only solves the problem of personnel cooling but also minimizes costs.