Corelle Winter industrial machine maintenance manual

Release time：2024-01-15

Publisher：小编

Reading volume：925

Air conditioner daily maintenance in winter

Air conditioner daily maintenance

To pay attention to the chassis cleaning, every day should press the control board on the “ Cleaning ” Key for water cleaning, to prevent bacteria, odor.

Air conditioner periodic maintenance

The unit runs for 1-2 months, if the wet curtain, filter screen is blocked or the site is too dirty, it should be cleaned in time to avoid machine failure or affect its operation effect.

End of winter maintenance

In order to prevent freezing damage to the body and the breeding of mosquitoes, when it is stopped for a long time, the tap water should be turned off and then the cleaning button should be pressed to remove water, and the power supply should be cut off.

Air conditioner main engine cleaning method

Power supply precautions

Disconnect the main power supply (disassemble the control board, so as not to mislead someone to start, causing danger)

Disassemble the filter

Unscrew the screw on the filter net, lift the filter net upward, and then pull the filter shading part outward, that is, remove the filter net.

How to clean it?

Soak and rinse with clean water (do not put any chemicals, so as not to corrode the wet curtain and filter, water pressure should not be too high, so as not to damage the filter and wet curtain)

Spray pipe flushing method

First, cover the fan with waterproof material, connect tap water to the spray pipe and cleaning port, and rinse the spray pipe with clean water.

Finishing step

Wash the bottom basin of the host with clean water, reinstall the eight filters or wet curtains back to the host, reconnect the main power supply of the environmental protection air conditioner, and then perform other operations after 5 minutes.

Cooling fan host cleaning method

Remove the wet curtain

Unscrew the top of the wet curtain first. Hold the shutter at the top of the wet curtain, pull the wet curtain gently outward and then lift it slightly upward to remove the wet curtain.

Remove top cover and pipe assembly

Unscrew the top cover first, then lift the top cover up and take it off. Loosen the hose band on the water supply pipe and loosen the water supply pipe, lift the cloth pipe assembly up and remove.

Cleaning of the cloth pipe

If the hole on the cloth pipe is blocked, it can be dredged with wire, and then clean the stain on the cloth pipe with clean water.

Chassis and accessories cleaning

Clean the chassis: Use a soft cloth or brush to clean the chassis

Clean the leaf: Use a soft cloth to wipe the leaf. Be careful not to drop dust from the blades into the duct

Clean the water level sensor: the stain on the water level can be cleaned with a small wet cloth

Cleaning the pump: brush can be used to clean the stains on the pump and its filter net

Clean the drain valve: Pay attention to the dirt at the bottom of the drain valve

Wet screen cleaning

Wash the wet curtain from the inside out with clean water (Note: the water pressure should not be too high during cleaning, it is forbidden to use acid or alkaline cleaning detergent to clean the wet curtain)

Filter cleaning

Unscrew the back cover of the filter and remove the stain on the filter element.

Put it back

After cleaning, install the machine in reverse order according to the removed steps. (Warning: When cleaning the unit must stop and turn off the power supply, otherwise there will be a risk of electric shock or other injuries to the human body.)

Source Statement：This article is originally edited or compiled by Guangdong Symphony Keruilai Air Coolers Co., Ltd.，Ltd. If reprinted, please indicate that it comes from Guangdong Symphony Keruilai Air Coolers Co., Ltd.。The above content (including images and text) is sourced from the internet. If there is any infringement, please contact our website promptly（400 168 3989）。

Corelle Winter industrial machine maintenance manual

Everyone is watching